Hello, Is there any way to set -1 day per default when you run CM25? In all profiles, it opens up to today's date and today's time per default.Then, you can adjust manually the position on time scale. In this case, I would like to do it automatical...

Hello, I am facing an issue while putting in the selection screen of CM25, the field 'Location'. Goal: Fill location in the selection screen and the system selects the work center linked with the corresponding location. First attempt: I used ST...

Hello Friends, I have a doubt regarding the following scenario: HALB Material with PD MRP Type and it has a Production Order created. It has one component ROH in their Bill of Materials. ROH Material (Component) with MRP Type = ZV Reorder Point...

Hello community, I have a requirement to check if it is possible to highlight the line representation in the planning table of CM25. It should be highlighted in another colour if the production order has a shortage of material which means that it h...

Hello Network, Is there any way to set to blank this field ALTST-STZU when an alternative bom is removed. First I create a BOM (no alternative), then I create a second bom which is alternative, so this field ALTST-STZU becomes 1, then I remove th...