Variants

[Former Member]

Hello folks,

<i>I am having a question regarding variants. Here is my problem.

I am having a field 'field1' on the selection screen declared using select-options (no intervals)and disabled for input.

The values in to this field are populated in the following way using a button created on the selection screen.

The button on the selection screen which when clicked will bring up a list of values. Select all entries and these entries will be populated in to 'field1'.

Then I had saved it as a variant. Again when I came back and selected the variant...I am able to see all values selected earlier for 'field1' but I am not able to modify the values (deselect some entries or deselect all...infact, I want to make changes to the field1 list...like add or delete some entries). I am wondering how this can be handled???. Please suggest.</i>

Thanks,

Message was edited by: Naren Somen

[Former Member]

Hi Naren,

You have disabled the field for input.Is there any purpose for that.You can enable for input so that you can have access to that field.

[Former Member]

Hi Naren,

As Phani mentioned correctly When you have maintained Field as input disabled that system won't allow you modify the variant as "Input disabled:. Please make your selection-option field Enabled then it will allow you to change the variant.

Lanka

[Former Member]

When the Super BOM is built, there could be a need to select “few” characteristic values by Engineering/Manufacturing team to choose correct dynamic BOM. Sales team would give 95% requirements, but it defines Sales pricing & sufficient confidence to accept the order. But these 95% characteristic values may not correctly define Dynamic BOM / Dynamic Routing. Remaining 5% has to be chosen by appropriate teams. How, When & Where the selection of remaining appropriate characteristic to be done by Engg/Mtg teams?