System Setting for Package Check

[Former Member]

Hi

How can the global 'package check' switch be activated or deactivated? Where is this customizing done? Is it possible to set the Package Check attribute specific to a package? How could this be done?

Thanks

Lakshmi

[Former Member]

Hi

How can the global 'package check' switch be activated or deactivated? Where is this customizing done? Is it possible to set the Package Check attribute specific to a package? How could this be done?

Thanks

Lakshmi

[Former Member]

Are you talking about changeover package?.

Please let me know.

Thank you.

regards,

Karun M

[Former Member]

Hi Karun

If I set visible elements thro' package interface or if I specify use access for a user package, this will have effect only if the Package check is activated. For eg., even if I have specified the Error Severity as error in Use access for a provider package, SLIN does not show me an error even if I have used the visible elements of this package. This would happen only if the package check setting is active. I am not sure where this could be done.

Thanks

Lakshmi

[Former Member]

Hi lakshmi,

Did you check the 'Restriction on user packages' flag at the Restriction on user packages tab?.

I hope this would help you to resolve your issue.

Thank you.

Regards,

karuna M

[Peter_Inotai]

You can activate it via PAKPARAM table. Check OSS Note 648898 - Switching on the package check.