steps for debugging a transaction VA01

[Former Member]

dear experts,

can you please guide me through the steps I need to take to debug a programme transaction VA01?

Thanks

[Former Member]

Hi,

Use:

Open Tcode-->

Enter /H in the command prompt and Press Enter.

Run the TCode it will take you to Debugger.

Regards,

Gurpreet

[Former Member]

Get a cup of coffee and send you telephone to voicemail. You're not going to want to be disturbed for quite a while

Rob

[former_member156446]

Hi, there nothing spl in Program for Tr. Va01.. its just like any program... but it has more code and more includes...its better if you can have a manual look and put couple of breakpoints here and there...and then start debugging..

[Former Member]

Thanks both, sounds good.

The reason I want to debug is find why I get a popup.

I do know the transaction /h but cant figure out how I could use the steps and get disoriented.

Thats why I would prefer a couple of examples to get a general feel about this.

Thanks for helpng me here.

Anything you want to yet ask me?

[Former Member]

put /h and press the enter after that goto BREAKPOINTS> BREAKPOINT AT> in message give call function , it will stop the all function module , somewhere you get your popup FM..

[Former Member]

Hello

Search the forum for 'debug popup' .

This wll help you to get into debug after the popup appears.

This will let you look at the call stack and perhaps determin how you got there.

Regards

Greg Kern

[Former Member]

ok