Spool status Incorrect

[Former Member]

Hello Everyone

I have one problem. I have configured PO release in such way that when ever user will release and save PO , immediate print command will be sent.

Now i have two transactions ME29n and ME28 to release PO. At backend both transactions use the same program and form to print.

When i run ME28 , print command is sent immediately and i can see spool completed successfully in SP01.

When i run ME29n, 1st time i can see a message that PO is changed after save , but when i see spool, spool does not get created.

When i run ME29n, 2dn time for the same PO, if i go to check message setting and come back to main screen without doing any changes, and press save, spool gets generated and completed successfully.

I tried to debug both the transactions number of times, then in debug , both transactions ended up in giving me spool status 'Incorrect'.

(Don know the reason if this is due to debug or something else )

So i am not able to understand the reason behind this situation.Assist.

Thanks

[Jelena_Perfiljeva]

I am honestly unable to understand what exactly is the question (you need to be more specific, SDN is not a Help Desk). In the subject you're saying "incorrect" but then "can see spool completed successfully in SP01". Which one is true?

In any case, my guess is that you need to change the output configuration. If it is required to perform two transactions then the output should not be triggered until the second transaction completes. There is also separate configuration for the initial output and output for changes in POs. And, on top of that, in SP01 you should be able to see an explanation what is "incorrect".

Actually this is not really an ABAP question but the output configuration, so ask your MM/PTP consultant.

[Former Member]

Hi

Thank you very much for your reply.

But i have clearly mentioned if you havnt read it properly, that when i am debugging both the transactions ME29n and ME28, spool status is ending in 'Incorrect' Status.

ME29n is to release PO. When 1st time i am saving this transaction after releasing PO, spool is getting generated with status 'Incorrect'.

When i run the same transaction ME29n 2nd time,without changing anything, spool is gettting generated successfully.

So i tried to find out the reason behind this,and so to debug the transactions, it ended up giving me spool with status 'Incorrect'.

But problem i have already found out problem. So i am closing this question.

[Former Member]

Hi Manesha,

I am facing the same Issue after i debugged my spool status is gettin set to "Incorrect" status, could you please tell me what was the problem, I am unable to find it?

Thank you.