Community
Application Development and Automation Discussions
Join the discussions or start your own on all things application development, including tools and APIs, programming models, and keeping your skills sharp.
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
Read only

Smartform Alignment issue

Former Member

‎2014 Sep 26 11:32 AM

0 Likes
1,451

Hi,

I have a smartform for remmittance invoice. This smart form is attached to the transaction and when i run the transaction then this smartform automatically goes to PDF file. Now, when I give printer as LP01 then Footer appears normally and well alligned. But when I give Local Printer for this then Footer don't appear as alligned and also it appears in Bold.

I need to overcome this issue for Local printer. May I know what exact changes I need to do for Local Printer and How ?

Also, without changing printer setting can I achieve this by doing changes in Smartforms and how?

Many Thanks.

5 REPLIES 5
Read only

former_member1716
Active Contributor

‎2014 Sep 26 11:54 AM

0 Likes
970

Hi,

Please enter your output device name in the T-Code SPAD , I think there you can control the device settings. Hope this helps.

Regards,

Satish

Read only

former_member1716
Active Contributor

‎2014 Sep 26 11:56 AM

0 Likes
970

As soon as you enter the T-Code yoy will be having a tab named Device Attributes, There give your prefered settings. Also check for other settings.

Regards,

Satish

Read only

Former Member
In response to former_member1716

‎2014 Sep 26 12:03 PM

0 Likes
970

Hi Satish,

Thanks for the reply.

In SPAD, If i'll make same setting for my Local Printer in the tab Device Attributes and AccessMethods which is there for LP01. After changing this should solve my problem, right?


Read only

former_member1716
Active Contributor
In response to former_member1716

‎2014 Sep 26 12:07 PM

0 Likes
970

Please check from you end i have not encountered such an issue but we faced a different issue, Hopefully it should work for you. Please let us know after the change.

Regards,

Satish

Read only

Former Member

‎2014 Sep 26 4:29 PM

0 Likes
970

Without changing Printer Settings you cannot achieve this. Once one Print/Print Preview is triggering fine means there is no issue in Form Design.

In this case may be the issue is While assigning the Font Families to Printer Output Device some Print control issue is there.  You can check this Font Family assignment to a Printer Output Device in SE73. if required try to adjust this.

Thanks,

Venkatmani.