show matnr diffrent

[Former Member]

i made a ztable and declare zmatnr as matnr(18).

i saw the data of the field like this 22-222222-22

but when i double click on the raw i see the matnr

22-22-

why?

[Former Member]

i made a ztable and declare zmatnr as matnr(18).

i saw the data of the field like this 22-222222-22

but when i double click on the raw i see the matnr

22-22-

why?

[Former Member]

zmatnr(18) type c.

[FredericGirod]

Do you use any field exit ?

Did you try to desactivate the field-exit into the option of your SE16 ?

Rgd

Frédéric

[Former Member]

Hi,

MAtnr is of type C with 18 lenght.

Use

Data: ZMATNR(18).

Regards,

Tanveer.

<b>Please mark helpful answers</b>

[Former Member]

HI

GOOD

OPEN THE ZTABLE

IF YOU R DELCARE THE COMPONENT TYPE AS MATNR(18) THAN MAKE IT MATNR AND PRESS ENTER IT WILL TAKE THE DEFAULT VALUE,OR ELSE YOU WANT TO DEFINE YOUR OWN LENGTH THAN YOU CAN DECLARE YOUR OWN DOMAIN FOR THIS AS PER YOUR REQUIRED LENGTH.

THANKS

MRUTYUN

[Former Member]

Matnr is of length 18

so declare DATA : ZMATNR(18) type C .

HOPE THIS HEPLS

THANKS& REGARDS

NARESH

[Former Member]

hi,

declare the zmatnr as <b>matnr</b>. that will take care.

Regards

vijay

[Former Member]

i declare matnr as data element MATNR and make enter.

now.

i eneter se16 make F* i see the row very good.

now.

i double click therow to see it alone i see the matnr diffrent and not good

[FredericGirod]

That's the effect of the field-exit.

go in the option, and desactive field-exit ...

[Former Member]

Hello Liat,

Check if the conversion exit is causing any problems.