SELECT-OPTIONS Multiple selection

[Former Member]

Hello

I have the following line of code:

   SELECT-OPTIONS: p_matnr FOR mara-matnr.

The users would like to use the multiple selection button to paste/upload from the clip board but unable until at least one entry is entered before the multiple selection will work.  Is there a way for the multiple selection to work without entering a material?

THANKS

[Former Member]

Hello Gary,

Is your Select option is OBLIGATORY ??

It happens only if the selection option is obligatory, remove the obligatory statement and try.

Regards,

Thanga

[sreeramkumar_madisetty]

In the above screen,bottom second right option is for load the data from clipboard so you can use this option..right

Thanks,

Sreeram

[ThangaPrakash]

Hello Gary,

Is your Select option is OBLIGATORY ??

It happens only if the selection option is obligatory, remove the obligatory statement and try.

Regards,

Thanga

[Former Member]

Thanks for quick response

I added obligatory see below:

   SELECT-OPTIONS: p_matnr FOR mara-matnr obligatory.

but I can not get to the Multiple Selection screen unless I enter a value on 1st screen.  I would like to go directly to the Multiple Selection Screen without entering a value

[former_member206479]

Hi Gary,

Just declare your variable like

data: gv_matnr type mara-matnr.

then declare select options

select-options s_matnr for gv_matnr.

with this you will not get any problem to go to extension to provide multiple range of values. If any thing you need revert back.

Regards,

Venkat.

[Former Member]

Remove the OBLIGATORY then check if "p_matnr" is initial (selection option are internal tables) when the user run the report.

[Former Member]

Hi Gary, Clicking the button shown below bring up the multiple selection screen without requiring a value. Do not add the obligatory keyword on the select-options statement as pointed out by Ramon.

see below: