Save data

[Former Member]

Hi Friends,

I have created table control in screen painter. I am able to enter the data, but not able to save the same.

The table control is created using wizard.

Pls guide me to correct the problem.

Thanks in advance,

Mark K

[Former Member]

Hi Mark,

You can go through this document.

http://esnips.com/doc/48bd95e8-facc-4932-b923-465ba59bad24/Table-Control.pdf

Regards,

SP.

[Former Member]

Hi Mark,

Just look into these two demo programs. They done with your requirement.

<b>DEMO_DYNPRO_TABLE_CONTROL_1

DEMO_DYNPRO_TABLE_CONTROL_2</b>

Thanks,

Vinay

[Former Member]

Hi Vinay,

What is the T-code to execute these two programs.

If I execute these programs, it will give more idea about the program.

Pls help.

Regards,

[Former Member]

Hi Mark,

You can view these reports with SE38. I checked these two reports and they are not assigned to any transaction.(I refered with SE80 and TSTC tables).

I think you need to create a table control in Screen Painter using SE51 and use this code at approiate places.

This may help you in analysing things.

Thanks,

Vinay

[Former Member]

Hi,

check this help..

https://www.sdn.sap.com/irj/servlet/prt/portal/prtroot/com.sap.km.cm.docs/documents/a1-8-4/table control in abap.pdf

Regards

vijay

[Former Member]

Hi Vijay,

Re: Save data

Posted: Jun 30, 2006 3:29 AM Reply E-mail this post

Hi Vijay

I tried the code given in this link.

https://www.sdn.sap.com/irj/servlet/prt/portal/prtroot/com.sap.km.cm.docs/documents/a1-8-4/table control in abap.pdf

The problem observed is that, it it not saving.

Kindly guide me.

Regards,

Regards

vijay