2006 Oct 17 7:04 AM
I have created a selection screen report.
after giving warning message, i have to put back control to main screen.
If i am raising a warning message, it is giving an error and control is going to blank screen.
how to put control on main screen?
we can put back the control to main screen by putting warning message in
at selection-screen event rather then start-of-selection.
2006 Oct 17 7:07 AM
hi,
its better to give the message type as 'I'.
message 'check this answer' type 'I'.
rgds
anver
if hlpful pls mark points
2006 Oct 17 7:08 AM
A Warning message will not stop the execution of the report further.
1. You will have to issue a ERROR Message
OR
2. Issue a warning message and then use a STOP statement or use the EXIT statement.
Regards,
Ravi
Note : Please mark all the helpful answers
2006 Oct 17 7:12 AM
I have written statements as follows:-
MESSAGE 'Selection was not restricted.' TYPE 'W'.
STOP.
Stop is in the code. but the warning message is not putting on the main screen.
2006 Oct 17 7:15 AM
warning type does not stop u at the screen, its just a warning that will prompt u and will continue.
so better give a ERROR type message
Regards
- Gopi
2006 Oct 17 7:18 AM
In my case, Error and warning both are putting me on the blank screen. I wanted to put the control back to main screen.
2006 Oct 17 7:20 AM
Can you post the code please?
2006 Oct 17 7:28 AM
start-of-selection.
*If the Selection Crieteria specified
IF S_BUDAT[] is not initial OR
S_BWART[] is not initial.
Do processing
else. "Give Warning message
endif. "Selection Criteria
2006 Oct 17 7:33 AM
<u><i><b>EXIT.</b></i></u>
Add the EXIT as shown.
2006 Oct 17 7:35 AM
simple, try like below.
MESSAGE W....... WITH '....'.
CALL SCREEN <SCR NUM>.
<SCR NUM> SHOULD BE THE SCRREN NUMBER OF THE SAME SCREEN WHICH U WANT TO BE IN.
2006 Oct 17 7:43 AM
Both EXIt and call screen are not putting me back to main screen.
2006 Oct 17 7:46 AM
oh,
with warning message ?& error message, current program will be terminated , so u cannot call back ur screen.
so, only solution would be , try changing it to status or info message if possible.
2006 Nov 24 8:07 AM
Bluesky
