regarding debugging

[Former Member]

how to debug standard transaction like MM01

?????????????

[Former Member]

Hi

Like any transaction: run MM01, insert /H in the prompt and the then press ENTER.

Max

[Former Member]

hi,

just before running the transaction - type /h in the command field and run immediately the mm01 transaction.

follow the debuggin steps...

reward points please

close the topic if answered properly

[Former Member]

Hi Subash,

Open T-CODE MM01 type /h in the place where you normally type in your T-code and press enter. Proceed from there as usual.

Revert back if you have any other problems.

Regards

Aneesh.

[Former Member]

get in to the second screen after that in main tool bar (where u can enter the transaction <b>just type /h</b>

and press enter after that when u click on some thing in the MM01 it directly goes to debugging mode(it applicable for <b>first screen</b> also)

[Former Member]

Hi, For Any transaction

type /h in the command field and press enter

u then enters in the debug screen ...then folow normal procedure for debugging ..

Hope it helps ..

Praveen.