read table

[Former Member]

Please use more informative subject in future

hi,

I have a internal table as follows.

po no | item | state |

45 10 ap

45 10 sp

45 10 pp

46 10 sf

46 10 as

I am useing the read table syntax for this table .

for pono 45 and 46 i want read the records.

but read table is triggring for first record only.

can any body explain how read the record of 46 also.

thanks,

padmaja.

Edited by: Matt on Mar 18, 2009 7:46 AM

[Former Member]

Please use more informative subject in future

hi,

I have a internal table as follows.

po no | item | state |

45 10 ap

45 10 sp

45 10 pp

46 10 sf

46 10 as

I am useing the read table syntax for this table .

for pono 45 and 46 i want read the records.

but read table is triggring for first record only.

can any body explain how read the record of 46 also.

thanks,

padmaja.

Edited by: Matt on Mar 18, 2009 7:46 AM

[I355602]

Hi,

Read statement will read the very first line matching the condition.

So try using:

loop at itab where po_no = '45' or po_no = '46'.
  write: / itab-po_no, itab-item, itab-state.
endloop.

Hope this helps you.

Regards,

Tarun

[Former Member]

Hi,

You can LOOP statement with where clause or

Read Statement will work for each entry only when it is

inside the LOOP statement with KEY mentioned.

Regards

Mansi

[Former Member]

Hi,

Do like this.

loop at itab into wa.

read table itab into wa with key po_no = wa-po_no.

• your logic, if any*************

endloop.

this will read every record.

Cheers,

Rudhir

[Former Member]

Hi,

Either used

At new po.

read table it into wa.

endat.

or

put loop it into wa.

endloop.

Regards,

Anagha Deshmukh

[Former Member]

Hi Padmaja

Use the Loop Statement instead of the Read statement since Read statement will give you the very first line of the matching condition.

Hope this helps.

Harsh

[Former Member]

hi,

use loop....end loop it select all th evalues in the internal table.

regards

Ritesh J

[matt]

Please use more informative subject in future

[Former Member]

Hi,

Loop the internal table with where condition or llop the table and use read statement within that.

Sort the internal table before that.

Thanks.

[Former Member]

Hi,

Reading the intrenal table will only be done either by using the READ statement within the loop -endloop or using the WRITE statement again with in the loop-endloop.

As both the statement will read the table at the curretn index only, to read the other entry you need to do it in loop-endloop or in lopp that run from first index to last value(sy-dbcnt).

Pooja

[Former Member]

answerd