Put logo on selection screen

[Former Member]

Moderator message - Please respect the 2,500 character maximum when posting. Post only the relevant portions of code

code i have done to put logo on selection screen. It works but problem is that same logo i am getting in result screen that i don't want.

Edited by: Rob Burbank on Apr 30, 2010 10:56 AM

[Former Member]

Moderator message - Please respect the 2,500 character maximum when posting. Post only the relevant portions of code

code i have done to put logo on selection screen. It works but problem is that same logo i am getting in result screen that i don't want.

Edited by: Rob Burbank on Apr 30, 2010 10:56 AM

[Former Member]

Check this code.......

DATA: docking_cont TYPE REF TO cl_gui_docking_container,
      cl_pic       TYPE REF TO cl_gui_picture,
      url(256)     TYPE c .

PARAMETERS:p_test TYPE c.


AT SELECTION-SCREEN OUTPUT.

  CREATE OBJECT cl_pic
         EXPORTING parent = docking_cont.

  CALL METHOD cl_pic->set_3d_border
    EXPORTING
      border = 5.

  CALL METHOD cl_pic->set_display_mode
    EXPORTING
      display_mode = cl_gui_picture=>display_mode_stretch.

  CALL METHOD cl_pic->set_position
    EXPORTING
      height = 55
      left   = 750
      top    = 08
      width  = 350.

  CALL METHOD cl_pic->load_picture_from_url
    EXPORTING
      url = 'C:\Documents and Settings\satyajit.mohapatra\Desktop\test'.


START-OF-SELECTION.
  WRITE p_test.

  CALL METHOD cl_pic->set_visible
    EXPORTING
      visible           = ' '
    EXCEPTIONS
      cntl_error        = 1
      cntl_system_error = 2
      OTHERS            = 3.

You need to use method SET_VISIBLE.......

[former_member206439]

Hi Rajan,

You can write the below LOGIC under AT Selection-screen output.

AT SELECTION-SCREEN OUTPUT.
PERFORM show_pic.

*&---------------------------------------------------------------------
**& Form show_pic
*&---------------------------------------------------------------------
FORM show_pic.
CREATE OBJECT picture_control_1 EXPORTING parent = docking.
CHECK sy-subrc = 0.
CALL METHOD picture_control_1->set_3d_border
EXPORTING
border = 5.

CALL METHOD picture_control_1->set_display_mode
EXPORTING
display_mode = cl_gui_picture=>display_mode_stretch.
CALL METHOD picture_control_1->set_position
EXPORTING
height = 55
left = 750
top = 08
width = 350.

CALL METHOD picture_control_1->load_picture_from_url
EXPORTING
url = 'C:\zpic.gif'.

*here you give the path where your pic is stored on the desktop
IF sy-subrc NE 0.
ENDIF.
ENDFORM.

Regards

Naresh

[Former Member]

thanks