Community
Application Development and Automation Discussions
Join the discussions or start your own on all things application development, including tools and APIs, programming models, and keeping your skills sharp.
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
Read only

Posting IDocs.

Former Member

‎2007 Mar 23 4:45 AM

0 Likes
386

Hi,

I am using an Idoc of type cond_a04 and message type cond_a in my abap program.I have filled the data into its control and data sections and tried to post it.After checking it in WE05 I got an error of status 56 saying that EDI partner profile not available.I am unable to understand this message.I have set up the partner profile through WE20 and have passed the same values to the control data section of the idoc.Please help me to resolve the issue.

Hi,

I am using an Idoc of type cond_a04 and message type cond_a in my abap program.I have filled the data into its control and data sections and tried to post it.After checking it in WE05 I got an error of status 56 saying that EDI partner profile not available.I am unable to understand this message.I have set up the partner profile through WE20 and have passed the same values to the control data section of the idoc.Please help me to resolve the issue.

Reply
2 REPLIES 2
Read only

Former Member

‎2007 Mar 23 5:05 AM

0 Likes
368

Hi sandeep,

make sure that the partner profile ur using is active for both sender and receiver. The test tool may help in checking it.

Regards

Read only

Former Member

‎2007 Mar 23 5:06 AM

0 Likes
368

Hi,

Check the config in the WE20 partner profile creation, whether all the correct info was attached or not in Outbound/Inbound parameters i.e message Type etc.

regards,

Anji