Partner XXX does not exist for partner function LS;

[Former Member]

Hi all,

I'm trying to configurate an outbound idoc for scheduling agreement (me38).

I make the follows steps:

1- NACO

     - Create an access sequence

     - Configurate an output type

     - Add some condition records

2- WE20

     - Select partner type LS

     - Create an ORDERS outbound parmtrs

          - Partn.Type  = LS

          - Partner Role = LS

          -  Message Type = ORDERS

          - Basic type = ORDERS05

               Message Control

                    - Application = EF

                    - Message type = MyMessageType

                    - Process Code = ME10

But when i go to me38 and trying to create the message, i receive the warning:  Partner xxxx does not exist for partner function LS

What i miss on my configuration?

Thank all advance.

[Former Member]

Hi all,

I'm trying to configurate an outbound idoc for scheduling agreement (me38).

I make the follows steps:

1- NACO

     - Create an access sequence

     - Configurate an output type

     - Add some condition records

2- WE20

     - Select partner type LS

     - Create an ORDERS outbound parmtrs

          - Partn.Type  = LS

          - Partner Role = LS

          -  Message Type = ORDERS

          - Basic type = ORDERS05

               Message Control

                    - Application = EF

                    - Message type = MyMessageType

                    - Process Code = ME10

But when i go to me38 and trying to create the message, i receive the warning:  Partner xxxx does not exist for partner function LS

What i miss on my configuration?

Thank all advance.

[Former Member]

Hi Eric,

Remove the partner role as LS from the partner profile and try executing the report. Also you may need to create the distribution model in BD64 with sender system as your SAP system and the logical system as destination system.

Cheers

~Niranjan

[JL23]

I think this blog can you give a lot insight into the steps needed to EDI messages:

http://scn.sap.com/community/pi-and-soa-middleware/blog/2009/11/10/configure-edi-message-control-bas...

[Former Member]

Hi Eric,

2- WE20

     - Select partner type LS

     - Create an ORDERS outbound parmtrs // ----Have you provide PORT  ?

          - Partn.Type  = LS

          - Partner Role = LS

          -  Message Type = ORDERS

          - Basic type = ORDERS05

               Message Control

                    - Application = EF

                    - Message type = MyMessageType

                    - Process Code = ME10

have you created below steps:

1.  Create an ORDERS outbound parmtrs // ----Have you provide PORT  ?

2. create distribution model by using t.c BD64.

Thanks,

[Former Member]

Guys,

Thank for all the replies, the problem was solved, had two problems, the first one is that for schedule agreement documents the application that is configurated on NACO is not EF is EL and when you modify on schedule agreement the document needs to be released (approved), it's like purchase order. So after i did this steps the warning message continues to show up but the idoc is generated without mistakes.

Thank you all!!!