Outbound idoc

[Former Member]

I have created a new message type & linked it.

Now the idoc is generated successfully in the source system but not distributed in the target system.

in target system too i specified the partner profile.

May i know wats the error.

Thanks in advance.

[Former Member]

I have created a new message type & linked it.

Now the idoc is generated successfully in the source system but not distributed in the target system.

in target system too i specified the partner profile.

May i know wats the error.

Thanks in advance.

[Former Member]

Two possible reasons,

1. The distribution model is not defined or cantains errors.

2. Message type does not exist in the target.

Check these out

[Former Member]

cdm is distributed in the target system & in the target system also i have this message type.

[Former Member]

hello,

check the CDMA part and it should be disitributed.

[Former Member]

could u specify more briefly?

[Former Member]

Whats the status of the idoc in the source and the target system ?

if source(sending logical system) idoc is 53 and target status(Receiving LS) of idoc <> 53

check the error status ..

regards,

Vijay

[former_member404244]

hi,

did u created model view in BD64 and distributed it.....chek the same..

regards,

nagaraj

[Former Member]

HI,

Check your Source & target system

It should have same settings in both systems

Check for all the following :

message type

Idoc type

rfc connection

partner profile

SAP version

Thanks

Sunil