oss note manual application

[Former Member]

Hi,

I have to implement a oss note before that i have to do some manual settings as given below

In program SAPMV45A in the screens

Screen : 8944

Screen : 8940

Screen : 8932

Screen : 8930

replace fields

VBAP-KMEIN by RV45A-/ICO/MO_KMEIN

VBAP-KPEIN by RV45A-/ICO/MO_KPEIN

and save and activate your entries.

but it is in table control. how can i do the changes as mentioned above in va01

[Nkrish]

Hi,

I think it means make the changes in the screen editor of the screens in SAPMV45A.

Open the above program=> double click in the screen numbers. It would open the screen editor, in that open the elements/attributes list. Change the names accordingly.

Regards,

Narayani

[Former Member]

hi,

but it is not editable in table control

[Nkrish]

hi,

You will have to go in to the change mode.Get an access key , and then change it.

Regards,

Narayani

[Former Member]

Hi,

I had gone in change mode .i can change any attribute of the field accept the field name as it is in the table control.

Regards,

mahesh

[Nkrish]

Hi,

Did you check in the note whether there are any steps mentioned on how to go about changing these fields. Usually in all notes if there are any changes the exact steps are given. Please go through the note carefully.

in the note => the steps usually will be given under the particular version that you are working.

Also please check on all the tabs in the attributes => there will be a tab where you can change the descriptions.

Regards,

Narayani

[Former Member]

Hi,

The manual changes mentioned in oss note, I have attached it in my question.the changes are not the description the field itself as mentioned above.

Thanks & regards,

Hemraj M K