multiple select-option

[Former Member]

Hi gurus,

I would just like to ask for your ideas on how can I output in ALV the multiple entries in your select-options. Here's the scenario, I have a select-option which is unit of measurement and it can have a multiple entries. The requirement is that I should output in ALV the conversion based on how many are the entries. If there are two entries, I should have 2 conversion and both of them should be in ALV.

I hope you can help me gurus.thanks in advance.

regards,

gizelle

[rainer_hbenthal]

Just to make it clear: when you enter km and miles in your select-option, you would like to have two columns in your alv showing a distance in km and in miles? And if you select additionally lightyears to your options, you would like to have three columns showng the distance in three units?

[Former Member]

Hi rainer,

Yes your correct. That's how my output should be.

Do you have any ideas on how can I make it?

Thanks in advance.

[rainer_hbenthal]

Yes, you have to build your fieldcatalog dynamically, the select options are nothing else but a table of type ranges, so just loop over the table like this:

loop at s_measure.

if s_mesure-low = 'km'.

CLEAR wa_fcat.

wa_fcat-fieldname = 'KM'.

wa_fcat-seltext_l = 'Kilometers'.

wa_fcat-seltext_m = 'Kilometers'.

wa_fcat-seltext_s = 'Kilometers'.

APPEND wa_fcat TO it_fcat.

endif.

if s_mesure-low = 'miles'.

CLEAR wa_fcat.

wa_fcat-fieldname = 'MILES'.

wa_fcat-seltext_l = 'Miles'.

wa_fcat-seltext_m = 'Miles'.

wa_fcat-seltext_s = 'Miles'.

APPEND wa_fcat TO it_fcat.

endif.

if s_mesure-low = 'LY'.

CLEAR wa_fcat.

wa_fcat-fieldname = 'LY'.

wa_fcat-seltext_l = 'lightyeras'.

wa_fcat-seltext_m = lightyeras'.

wa_fcat-seltext_s = 'lightyeras'.

APPEND wa_fcat TO it_fcat.

endif.

endloop.

Of course theres a lot more to do but i hope you get the point. You have to foresee every possible measurment and react on this.

[Former Member]

can i create dynamic tables for this? but I dont know how to create a dynamic table. I hope you could help me gurus.thanks.

[rainer_hbenthal]

Even if you are creating a dynamic table you have to fill the fieldcatalog like i showed you.

I really suggest that you limit down your measures to a fix amount of them and let the user choose via radiobuttons.

Your problem isnt solvable in this forum, its too complex using dynamic tables if you havent a glue of them.