Message type from Logical system

[Former Member]

Dear All,

I need develop an inbound where the info is coming from HR system. I found Message Type HRMD_A can be utilized for the development, however im not so sure if the message type HRMD_A is originally exist in my R/3 4.7 or it was being distributed by the HR system previously via BD64.

Please comment on how can i check for it.

Below are the related info for Message type HRMD_A that i found in my R/3 4.7:

Message type - HRMD_A

Basic type - HRMD_A06 (for release 620)

Process code - HRMD

Inbound FM - IDOC_INPUT_HRMD

Thank you.

[Former Member]

Hi,

HRMD_A message type exist in R/3 4.7

Regards

Arun

[Former Member]

Hi Arun,

Thanks for your reply. However i want to know on how to check if message type HRMD_A is originally exist in my R/3 4.7 or it was being distributed by the HR system previously via BD64.

Please advice.

[Former Member]

Hi,

Message types are not created by distribution from other system. Distribution is done so that partner profiles and all other set up done in one system should get reflected in another system.

If the message type exist in the system that means it belongs to that system only.

Go to transaction WE82 to get the message type, idoc type and the release.

Regards,

Atish

[Former Member]

Hi Atish,

Thanks for your reply. Let me recap my scenario and please point me out if i'm wrong again.

For my case, Message type HRMD_A exist in both R/3 and HR system. Since it exist, then we do not need to distribute from HR again via BD64. Right?

IDOC can be passed from HR to R/3 without any additional config right? Assume partner profile and RFC destination has been configured correctly.

Please comment.

[Former Member]

Yes. You are right. Only thing you need to take care is you are using the correct IDOC type in both the system.

Regards,

Atish