Loop statement in ABAP OO

[Former Member]

Hi,

I am trying to change a BADI interface and since BADIs use ABAP OO, a simple loop statement fails to work.

I need to loop through an internal table and for each record in the internal table I need to read another db table which has a field in common with the internal table.

Ideally,

Loop at lt_selections

select logsys from /bic/mzcs_unit where /bic/zcs_unit = lt_selections-cs_unit

endloop.

But this piece of code fails to work in BADI because of OO concepts.

Can anyone help me out here?

THank you

[Former Member]

Deep,

Actually the code below does work. It doesnt depend on OO concept in BADI or other.

May be there may be a type mis match between the field in the internal table and the key in the db table.

Check.

Regards,

[alejandro_lpez]

Hi,

Try using this code:

1. Create a work area to internal table lt_selections.

data: wa_selections like line of lt_selections.

2. Change the loop:

Loop at lt_selections into wa_wa_selections.

select logsys from /bic/mzcs_unit where /bic/zcs_unit = wa_selections-cs_unit

endloop.

or use FOR ALL ENTRIES statement:

select logsys from /bic/mzcs_unit

FOR ALL ENTRIES IN lt_selections

where /bic/zcs_unit = lt_selections-cs_unit.

Regards,

Alejandro

[RichHeilman]

As Alejandro said, if you are getting a syntax error, it is probably because <b>header lines are not allow in OO</b>.

data: wa_selections like line of lt_selections.
Loop at lt_selections into wa_wa_selections.
select logsys from /bic/mzcs_unit 
     where /bic/zcs_unit = wa_selections-cs_unit.
endloop.

Regards,

Rich Heilman

Message was edited by: Rich Heilman