initial, empty #-value in fields in the new abap debugger

[Former Member]

Hi,

after using the logical database with the get statement, I have a value in a field which is shown in the new debugger for the field ldb_structure-bukrs like this: '####'.

If I use the if-clause like:

IF ldb_structure-bukrs IS INITIAL.

<do-something>

ENDIF.

<do_something-else>

The <do-something>-part is left out in this case, because there are #-values in the empty field.

Where does this behavior come from? Just because there was a select and the field could not be filled? Why isn't it just empty?

Kind greetings,

Mario

Message was edited by: Mario Schmidt

[Former Member]

Hi,

after using the logical database with the get statement, I have a value in a field which is shown in the new debugger for the field ldb_structure-bukrs like this: '####'.

If I use the if-clause like:

IF ldb_structure-bukrs IS INITIAL.

<do-something>

ENDIF.

<do_something-else>

The <do-something>-part is left out in this case, because there are #-values in the empty field.

Where does this behavior come from? Just because there was a select and the field could not be filled? Why isn't it just empty?

Kind greetings,

Mario

Message was edited by: Mario Schmidt

[Former Member]

Perhaps it would be

IF ldb_structure-BUKRS IS INITIAL.

<do-something>

ENDIF.

<do_something-else>

Normally it is visualization subject, if you click in structure, in debugging you would be able to see the value of the fields of structure.

Regards

[Former Member]

Hi,

use below logic

if ldb-bukrs is initial.

write:/'test'.

else.

endif.

Regards,

Amole

[Former Member]

No, I'm sorry.

I'm using already ldb_strukture-bukrs is initial in the if statement. It was an error in the posting above.