IDOC problem

[Former Member]

Hi Guru,

I created one material in Target client and I created one IDOC through BD10.

Then in the receiver system in WE20 (Partner Profile ) I did inbound settings ( Message Type and Process code ).

In receiver system IDOC is being created but in WE09 it is showing error as 'IDoc with errors added'

Could you please tell me what is the problem with the same.

Thanks,

Sandeep Garg

[Former Member]

Hi,

Note the idoc number and execute the program RBDAGAI2 in the inbound system ..if it still doesnt work then check in we19..

Regards

Vasavi Kotha

[Former Member]

Hi,

I did the same but it is showing that IDOC with error added.

And status is 56.

Do I need to create the PORT and Distribution Model foe the same in Receiver systems also.

Thanks,

Sandeep Garg

[former_member404244]

Hi,

No need to create the port for the receiving system..U just have to create the source logical syatem and in the inbound paramters need to specify the message type and process code..

From source system u have to do the following things

1>create a RFC connection

2>create a TRFC porrt

3>create reciver logical system(and in the outbound paramters , specify the message type, basic type) and the port number.

4>BD50 (check the message type MATMAS radio button)\

5>Then in BD64 u have to first generate partner profiels and then need to distribute the model view to the reciever logical system..

Please check if u have doen all the above configs

then finally use BD10 to distribute the material.

Regards,

Nagaraj

[Former Member]

Hi sandeep,

If the idoc is failing with 56 status you need to check inbound partner profile, check in the recieving system.

Also if u have generated the partner profile from distribution model in sending system and you distributed your model view (Environment -> modelview -> distribute) then u need not create sistribution model in recieving system. Port is required only in sending system

Regards

Vinod

[GauthamV]

Did you execute BD75 after BD10 ?

Yes, port should be created in reciever also and should be attcached in We20.

[Former Member]

HI

in sending system you need to fill the inbound parameters and in the receiving system you need to fill the outbound parameters.

what is the status number which you are getting?

Thanks,

Anil

[Former Member]

I am getting status as 56.

[Former Member]

I am getting status as 56.

[Former Member]

I am getting status as 56.

[Former Member]

Hi,

YOu need to completely configure the ALE and then try to use the distribution transactions like bd10,bd12...etc..

[Former Member]

I am getting satatus as 56.