Community
Application Development and Automation Discussions
Join the discussions or start your own on all things application development, including tools and APIs, programming models, and keeping your skills sharp.
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
Read only

idoc - Multiple Destinations

Former Member

‎2011 Jan 18 1:52 AM

0 Likes
836

Hi,

Can I send same idoc to multiple destinations directly from SAP using ALE configuration?

At some forums, it was said that master data idocs can be configured with multiple receivers in idoc distribution model. Ours is not master data idoc, it is custom idoc. While I tried to configure multiple receivers in distribution model, it is giving me error message.

Can I configure multiple receivers in ALE distribution model?

thanks..HP

2 REPLIES 2
Read only

Former Member

‎2011 Jan 19 5:14 AM

0 Likes
566

What is the error you got when you create a distribution model?

Read only

Former Member

‎2011 Jan 20 7:32 PM

0 Likes
566

The best and easiest way I found sending same IDOC to multiple destinations is by proposing multiple outputs. Just add another partner number for that output type.

Note: This output type has to be configured to accept multiple issuing and the general output proposal should be on an inclusive strategy. So if you're using a standard output type (or one which is mirrored from standard) then you should be fine.

If you have to use distribution model, then you cannot have sender/receiver on a partner profile. Only one of these has to be setup.