how to do multiple selections for a selection screen object

[Former Member]

i need to select material (RMCBC_MATNR) from a selection screen. how do i facilitate for multiple selections.

plz help me out. thanks in advance.

kiran

[Former Member]

i need to select material (RMCBC_MATNR) from a selection screen. how do i facilitate for multiple selections.

plz help me out. thanks in advance.

kiran

[Former Member]

Hi Kiran,

at the end of the selection screen option you would find a button , please click on it and you can enter all the values you would want to check out for

[Former Member]

but how can i catch all those values and further use them. can u demonstrate that with a piece of sample code, if possible. thank you

[Former Member]

Kiran,

I am guessing that you have SELECT-OPTIONS in the selection screen. So, once you have entered mutlipel values by clicking on the button, all you have to do is

SELECT * FROM XXX WHEER COLUMN IN S_OPTION.

S_OPTION is your select options on the screen. It will take care of all the values entered.

S_OPTION is a internal table. Take a look at the help for the same.

Regards,

Ravi

Note : Please mark the helpful answers

[Former Member]

Hi Kiran,

You can use the Function Module <b>F4IF_FIELD_VALUE_REQUEST</b>. In that FM, there is a parameter for Multiple selection. You have to set it

as 'X'. Call the FM in this following event

AT SELECTION-SCREEN ON VALUE-REQUEST FOR RMCBC_MATNR .

<b>Whatever values that you have selected will be stored in the table parameter</b>.

Regards,

SP.

[Former Member]

Hi Kiran,

For declaring the material in the prgram use select option.

Example

SELECT-OPTIONS s_mat FOR mara-matnr.

On execution Just right of the field you will get an arroe press on that a box will be opened put all your materials in this box and execute.

For using the select options for fetching the code use it

SELECT matnr FROM mara INTO TABLE p_mara_table

WHERE mtart IN s_mat.

Message was edited by: mukesh kumar

[Former Member]

hi kiran

then why dont you do as below

data: begin of itab

matnr type matnr

end of itab.

Select matnr form mara

into itab

where matnr in (the select-option that you have defined for rmcbc_matnr)

itab will contain all the matnrs that you have defined in your selection screen.

Award Points for helpful answers

[Former Member]

Hi Kiran,

please check this small piece of code.

<u><b>Report</b></u>

tables : mara.

data : begin of itab occurs 0,

matnr type mara-matnr,

end of itab.

select-options : MATNO for mara-matnr.

select matnr from mara

into table itab

where matnr in MATNO.

loop at itab.

write : / itab-matnr.

endloop.

If found helpful, please do reward.