Group condition.

[Former Member]

Hi,

I have a requirement as below: I have a group condition(ZR09 which is scale based) which has to be calculated as follows: For every line item the net value is added and finally the condition ZR09 is applied. Now the problem is I have certain cases where the condition ZR09 is inactive(Because of exclusions). Currently the value of ZR09 is calculated based on whole line item net value.

The requirement is if for a particular line item the group condition ZR09 is inactive then the corresponding net value of the line should not be considered for calculating the group condition. I have written a scale based formula for this and assigned in the condition type. It works fine during creation of the sales order but when I add a new line item to an existing sales order the problem comes and the calculation of group condition is done based on certain other values.

Did any one faced this situation earlier. Again I think this issue can be solved by some customizing(Which I am not sure of). Can anyone suggest a work around for this?

Regards,

Murari.

[eduardo_hinojosa]

Hi

See Note 315792 - Group conditions of the same amount on item. It suggest how to create a VOFM and set it in V/06 for this condition in group key routine to avoid this kind of problems.

I hope this helps you

Regards

Eduardo