Find user exit

[Former Member]

In transaction code "CO11N", when i enter production order and click on "GOODS MOVEMENTS" button, next screen appears. I want to know which exit is fired on the save button of this screen.

[Former Member]

In transaction code "CO11N", when i enter production order and click on "GOODS MOVEMENTS" button, next screen appears. I want to know which exit is fired on the save button of this screen.

[Former Member]

Hi,

BADI Enhancement is WORKORDER-CONFIRM,Check this it will satisfy ur needs.

Regards

Kiran SURE

[Former Member]

When i entered "WORKORDER-CONFIRM" in SE19, it says

"Enhancement point WORKORDER-CONFIRM does not exist

" .

[Former Member]

Exits available for CO11N are as below:

CONFPP01 PP order conf.: Determine customer specific default values

CONFPP02 PP order conf.: Customer specific input checks 1

CONFPP03 PP order conf.: Cust. specific check after op. selection

CONFPP04 PP order conf.: Customer specific input checks 2

CONFPP05 PP order conf.: Customer specific enhancements when saving

CONFPP06 PP Order Confirmations: Actual Data Transfer

CONFPP07 Single Screen Entry: Inclusion of User-Defined Subscreens

CONFPS01 PS confirmation: Determine customer specific default values

CONFPS02 PS confirmation: Customer specific input checks 1

CONFPS03 PS confirmation: Customer specific check after op. selectio

CONFPS04 PS confirmation: Customer specific input checks 2

CONFPS05 PS confirmation: Customer specific enhancements when saving

CONF0001 Enhancements in order confirmation

CONFPI01 Process order conf.: Calculate cust.specific default values

CONFPI02 Process order confirmation: Customer spec. input checks 1

CONFPI03 Process order conf.: Cust. spec. check after op. selection

CONFPI04 Process order conf.: Customer specific input checks 2

CONFPI05 Process order conf.: Cust. spec. enhancements when saving

CONFPI06 Process order confirmation: Actual data transfer

CONFPM01 PM/SM order conf.: Determine cust. specific default values

CONFPM02 PM/SM order confirmation: Customer specific input checks 1

CONFPM03 PM/SM order conf.: Cust. spec. check after op. selection

CONFPM04 PM/SM order conf.: Customer specific input check 2

CONFPM05 PM/SM order conf.: Cust. specific enhancements when saving

I hope it helps.

Best Regards,

Vibha

Please mark all the helpful answers

[Former Member]

Hi Priti,

Go to Transaction CO11N and find name of the program.

Then goto Se38.

Give program name .Dispaly.

Then Find for Perform User_exit.

then u can get the User_exit.

If found helpfull.

Do reward.

Regards.

Eshwar.