EXIT_SAPLV61B_002 is not triggering in debugging mode for Tcode vf31

[Former Member]

Hi Experts,

Exit - EXIT_SAPLV61B_002 under Enhancement - VN00001 is not triggering in debugging mode for the Tcode VF31. I implemented this EXIT_SAPLV61B_002 in CMOD and kept break point. Is there any way to execute this exit in debugging mode or any other exits which is available for tcode VF31 other than these below enhancements

VCOM0001

VCOM0002

VCOM0003

VCOM0004

VN000001

Thanks

Babu V

[Former Member]

Hi Experts,

Exit - EXIT_SAPLV61B_002 under Enhancement - VN00001 is not triggering in debugging mode for the Tcode VF31. I implemented this EXIT_SAPLV61B_002 in CMOD and kept break point. Is there any way to execute this exit in debugging mode or any other exits which is available for tcode VF31 other than these below enhancements

VCOM0001

VCOM0002

VCOM0003

VCOM0004

VN000001

Thanks

Babu V

[former_member188724]

Hi,

Is the Project that you created in CMOD is active?

Regards,

K.S

[Former Member]

Hi K.S,

Thanks for your response.

Yes, it is an active.

Regards

BABU V

[Former Member]

Have you created the include ?

I would suggest create the include and put some code inside the code and put the debugger there and check .

You can out any code like

if 1 = 1.

endif.

[Former Member]

Hi Babu,

The user-exit for Print parameters needs to be set in configuration of the particular output type as well. Please see the screenshot below.

Regards,

Shashi Thakur

[Former Member]

Hi Shashi,

Thanks for your suggestion, I will check it if any doubt I will post message once again.

Regards

BABU V