ERROR MESSAGE

[Former Member]

Hi,

I want to trigger an error msg when sy-subrc <> 0 but i do not want to use any message class or message no.want to generate my own error message.

The syntax i used is

MESSAGE 'SUCCESS' TYPE 'I'.

however,i get the error message.

Three-digit error number XXX required in the 'MESSAGE EXXX.." Statement.

[Former Member]

hi,

create ur own message class by SE91.

there wiu can create ur own messages.

Than write like this.

MESSAGE s000(<b>zmsg_fmtr</b>)

<b>S</b> for Status Message

<b>zmsg_fmtr</b> is my message class

Hope it will b helpful.

Reward if useful.

[Former Member]

Hi,

check this,

message 'error' type 'I'.

Thanks,

Reward If Helpful.

[Former Member]

hi

MESSAGE i001 WITH text-026.

message i001(00) with 'sucess ful'.

regards

kk.

[Former Member]

Hi,

You can write like,

If sy-subrc <> 0.

message 'DATA ALREADY EXISTS!' type 'E'.

endif.

Regards,

pritha

Reward if helpful.

[Former Member]

hi,

create ur own message class by SE91.

there wiu can create ur own messages.

Than write like this.

MESSAGE s000(<b>zmsg_fmtr</b>)

<b>S</b> for Status Message

<b>zmsg_fmtr</b> is my message class

Hope it will b helpful.

Reward if useful.

[Former Member]

hi

pls follow as below

MESSAGE i001 WITH text-026.

message i001(00) with 'sucess ful'.

[Former Member]

hi,

you can use like

Message 'error message' type 'E'.

regards,

[Former Member]

Please try using following statement with your TEXT replacement in single quotes.

MESSAGE E999 WITH 'Please enter a valid Purch Org.'(001).

Note: you need to define a message class using statement MESSAGE-ID in the REPORT statement.

Award points, if this hint helps you.