Enhancement not detected while debugging

[Former Member]

I have a standard program SDORDE01, in which i need to add one field.

I have made an enhancement but there is no data in that field.

while debugging,enhancement is not getting detected.

can somebody please help??

[madhu_vadlamani]

Hi Lohani,

Check whether it is right one ot not.Keep a break point and see.

Regards,

Madhu.

[Former Member]

Hi,

Is it implicit or explicit enhancement?

You mean while debugging, you are not able to see the code you have written. Is that right?

Activate the code once again and see. Activation will regenerate the objects once again.

Cheers,

Raja.D

[Former Member]

Its an implicit enhancement. I have tried activating it again and then executing. But its not working. Also, while trying to put a breakpoint, its not allowing me to put it at the enhancement.

[Former Member]

Hi,

This is common with Enhancement and since your enhancement code is not generated properly, you cannot see in debugging and you cannot put breakpoint also.

Delete the logic you have written.

Create the implicit enhancement once gain from the scratch and see.

Cheers,

Raja.D

[Former Member]

Do you see this behaviour in the DEV system or after it has been moved to other systems that you see this behaviour in the new system?

check this sap note: 1567797 - Source code plug-in does not execute

Edited by: Kartik Tarla on Feb 8, 2012 4:26 PM

[aromalr]

Hi,

i had the same issue . I put a break <userid> statement and transported to QAS. in QAS i used the <userid> to test it. then the spot started functioning. After that I commented the break point and transported again.

regards

aromal

[vijaymanikandan]

Hi

Tell the enhancement spot that you are using in this program. I did try the an sample enhancement in the same program in our system and it works. Check the type of enhancement and try to active it properly. After activating check if you are able to see the code in the program display in the normal mode.

Regards,

Vijay V