conversion error in table control

[Former Member]

I have a table control with a field defined like dec 20, and i have a table field defined like dec 15 positions 4 decimals, with signe, so.. long = 20, and when i try to pass to the table control for example the value 409.3461-,it gives me a dump with error conversion telling me that the sign has lost, i have tried in the table control with dec 15 too , but the same, i would thank any help.

Thanks in advance

[Former Member]

Check the domain of the receiving field and make sure it allows the sign. If it doesn't, either change the domain so that it does allow the sign or use a different domain that does allow a sign.

(If it's an SAP domain, don't change it.)

Rob

[Former Member]

Hi Carlson,

It is better to use a char type variable with length 20 although it is supposed to hold a decimal value.

I have faced a similar type of problem and i did the same.

Or You may be getting the dump because the field is expecting 15 + 4 + 1(for sign) + 1(for decimal) so total 21 chars.

REgards,

Ravi

[Former Member]

Check the domain of the receiving field and make sure it allows the sign. If it doesn't, either change the domain so that it does allow the sign or use a different domain that does allow a sign.

(If it's an SAP domain, don't change it.)

Rob

[Former Member]

Hi,

I had faced the same issue with table controls and realized that the conversion error goes away if you put a 'V' in the Text attribute of the field. I had a field of type DEC 4, and I had to put in the text in the field as '___V' (3 spaces and a V at the end). In your case it looks like you will have to populate the field with 19 spaces and a V at the end.

I have seen the same thing in some of standard SAP screens, that is where i got the idea from, weird as it may sound.

Hope this helps.

Sudha

[Former Member]

Thank you very much for your quick replies, finally i have all data ok, excepting the text mask.

Thank you very much