Client 100 has status 'not modifiable'

[Former Member]

Dear All

I am getting the error message "Client 100 has status not modifiable"

when I am trying to maintain a table. Affected table has in T-Code SE11on tabstrip "Delivery and Maintenance"

the status "Display Maintenance Allowed". Neertheless I am not able to maintain the table.

Regards

Marco

[Former Member]

There is a basis setting that prevents table changes. Your basis administrator should be able to lift this parameter so that you can make the change. But you may need to get management to agree.

Rob

[Former Member]

thx for this great help.

[Former Member]

If your question is answered, please close it.

Rob

[Former Member]

of course not...

[Former Member]

Hi,

Kindly check the system status whether it is in modifiable status or in non-modifiable status in t-code "SE06".

In most of the cases in Development server it is in modifiable status only.

And also check the client has been open r not in t-code "SCC4".

Kindly contact your basis administrator they will help you.

Regards,

Anil.

[Former Member]

of course not...

Total Posts: 335

Total Questions: 141 (7 unresolved)

There is a 10 open post limit in the forum. If you don't close some soon, you'll be unable to post new ones.

Rob

[Former Member]

Rob Burbank

make fun about your Mama, OK? You should answer questions insted of playing the police rigth here! Are 4 years old?

[Former Member]

Hey Marco - what's with the attitude. I thought your question was answered and asked you to close it. But if it's not answered, it would help if you tried explaining why it's still not rather than being rude to those trying to help.

Rob

[Former Member]

Marco - have you considered searching the forum or Googling??

Rob

[Former Member]

Hi Rob,

yes.

I have found e.g. this URL

http://www.ikew.co.za/?p=186

Regards

Hakan

[sjeevan]

Good link Hakan, I was looking for a permanent fix for that OB52 problem in non production systems.

[Former Member]

Marco,

Mr. Burbank is the police on this forum. I wouldn't make him mad if I were you.

And I am confused by your response "of course not..." What does that mean? Did you get your question answered or not?

If you did, close the post. If you did not, explain further as to why it wasn't answered. Sarcasm doesn't motivate people when asking for help in any situation, whether it be on a forum or in your office.

[Former Member]

Dear Marco,

If you are getting this error while maintaining the entries in a table (Do not change standard table) Please check the table maintenance generator through SE11 .

You can see Recording routine with two radio button

1. Standard Recording Routine.

2. no, or user, recording routine.

Kindly select option 2 ( no, or user, recording routine ) and then you will be allowed to maintain the entries.

Regards,

Rahul Singh