checking a variable in a process which is already recorded

[Former Member]

If i have a long process recorded in ecatt with sap gui and i want to check a variable in the middle of the process, i dont want to record the process in ecatt again. Is it possible to process the ecatt to the place, where i want to check my variable and insert a "chegui" command?

[Former Member]

If i have a long process recorded in ecatt with sap gui and i want to check a variable in the middle of the process, i dont want to record the process in ecatt again. Is it possible to process the ecatt to the place, where i want to check my variable and insert a "chegui" command?

[pb3030]

Hi David,

I am not sure if you have tried splitting the SAPGUI command  at the "Methods/Properties" level, so that you will have n number of commands based on the methods. Now you can proceed with the chegui to check the variable that you are looking for.

Hope this will help you.

Steps to split the SAPGUI command.

click on the recorded SAPGUI command --> (rigth click) --> (select) Splitting at --> (select) Methods/Properties".

Regards,

PB

[AjayHS]

You can split the SAPGUI command at desired level.

Once you split multiple SAPGUI command is generated and then you decide to include CHECKGUI command

Thanks,

Aj

[AnanthNatarajan]

Hi David,

While recording you can split the SAPGUI command and then you can check the variable using CHECKGUI command.

I hope the below mentioned link might help you

http://help.sap.com/saphelp_erp60_sp/helpdata/en/10/f3383fe58d5900e10000000a114084/content.htm

Regards,

Ananth.