break-point

[Former Member]

Hi Experts,

i have a CALL-FUNCTION statement in a satandard program.

like this: CALL-FUNCTION '001'.

Exporting

IMPORTING

So i have put a break-point at this statement.

When i enter in debug mode at this statement and press F5 it is not going inside that. It is coming out of that FM.But when i open it manually form SE38 and double click on it then it is going in side..Actually it is User-Exit...Can any body tell me what is the problem.'

[Former Member]

You need to create a CMOD entry for the enhancement code of the FM. Look at table MODSAP for the enhancement code based on the FM Name.

[RichHeilman]

Yes, this function module will only be fired if the user exit which is associated with it, is activated. Please make sure that your enhancement is activated in CMOD/SMOD.

Regards,

Rich Heilman

[Former Member]

Hi

u might have wrote this CALL-FUNCTION '001' on If condition,so if that condition will not satisfy then it will not go inside.

or u do onthing

Goto inside of that CALL-FUNCTION '001' by double clicking on this and there put a break point.

so while dubugging it will go inside.

If helpful

Reward me points

Regs

Manas Ranjan Panda

[Former Member]

hi ,

Create a project in CMOD aan assign the exit to it, and activate the project and keep a break point and run the transaction.

Regards.

Syed

[Former Member]

Hi,

since there is no implementation to the Function module exit. so it is not going inside. create the Project in CMOD and implement the enhancement.and now check it.

Regards

vijay

[Former Member]

Hi All,

Thanks.Every thing is done.even when i press F5 at CALL CUSTOMER-FUNCTION '001'..it is not going inside that.

it is coming out of that.

[Former Member]

it's not goin ginside even though you have some code in your exit because your exit itself is INACTIVE,

Please activate it in CMOD/SMOD and I would re-generate your main program... just to be sure