Application Development and Automation Discussions
Join the discussions or start your own on all things application development, including tools and APIs, programming models, and keeping your skills sharp.
cancel
Showing results for 
Search instead for 
Did you mean: 
Read only

Assign a Transaction code to a Z program

Former Member
0 Likes
2,314

Dear all,

I had assigned a t-code to a new developed zprogram. When I enter a tcode to call the program, input selection criteria and run execution, the program had no response, then auto back to the initial R/3 interface. However, if i use SE38 to run the same program, the program can continuously process and output the result successfully.

Do anyone know what happen/ problems in this case?

Best regards,

Chris

1 ACCEPTED SOLUTION
Read only

Former Member
0 Likes
1,391

Dear all,

I have already assigned the tcode to the program, if I want to change the radio button to PROGRAM AND SELECTION SCREEN (REPORT TRANSACTION), how should I do it?

I cannot not check this option in an existing dialog transaction (SE93)

Chris

8 REPLIES 8
Read only

Former Member
0 Likes
1,391

Hi,

Goto SE93 and assign the tcode to the corresponding developed program and select the option as report.

Regards

Kannaiah

Read only

Former Member
0 Likes
1,391

HI,

Use the option Program and selection screen Radio Button and create the Tcode. It will work fine. I think you have selcted the wrong one while creating the tcode.

Regards,

Ram

Read only

Former Member
0 Likes
1,391

Open the code ..program in Se80 and then right click on the rpgram name goto ..create and then Transaction and then please assign the transactioncode gaian.......

I think that the T code you created was not attached to your program .... I think doing it again will help you..

Ragards,

Jayant

Message was edited by: Jayant

JAYANT KUMAR

Read only

Former Member
0 Likes
1,391

Hi,

go to se93 give your z transaction name press create it choose the 2nd radio button with report give your your report name next screen.

Regards

Sudheer

Read only

Former Member
0 Likes
1,392

Dear all,

I have already assigned the tcode to the program, if I want to change the radio button to PROGRAM AND SELECTION SCREEN (REPORT TRANSACTION), how should I do it?

I cannot not check this option in an existing dialog transaction (SE93)

Chris

Read only

0 Likes
1,391

Hi,

Remove the previous TCODE and create new and check the report option.

Regards

Kannaiah

Read only

0 Likes
1,391
Goto SE93
Give the TCODE name and click on change button
In menu Edit--->Change Transaction Type
Read only

Former Member
0 Likes
1,391

I am not sure about your question you can go to se93 and give yor transaction code and go to change mode check menu path edit--> change transaction type (shift+F1)

regards

shiba dutta