Community
Application Development and Automation Discussions
Join the discussions or start your own on all things application development, including tools and APIs, programming models, and keeping your skills sharp.
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
Read only

ALE Material Transfer

Former Member

‎2006 Mar 08 1:40 PM

0 Likes
924

I am attempting to transfer material master data from our production system to development, but seem to be missing a piece of something.

When I use transaction BD10 (Material Send) I get the following message: "0 communication IDoc(s) generated for message type MATMAS". This process should have generated an outbound Idoc but it doesn't.

The test uses 1 material and at first appears as if it will work "1 master IDocs set up for message type MATMAS". But then the above message appears and no Idoc is created.

Any ideas?

I am attempting to transfer material master data from our production system to development, but seem to be missing a piece of something.

When I use transaction BD10 (Material Send) I get the following message: "0 communication IDoc(s) generated for message type MATMAS". This process should have generated an outbound Idoc but it doesn't.

The test uses 1 material and at first appears as if it will work "1 master IDocs set up for message type MATMAS". But then the above message appears and no Idoc is created.

Any ideas?

Reply
4 REPLIES 4
Read only

abdul_hakim
Active Contributor

‎2006 Mar 08 1:45 PM

0 Likes
713

Hi Jim,

Could you please check whether the partner profile exists for both the system also confirm whether the distribution model has been distributed from prod system to dev system.

Regards,

Abdul Hakim

Read only

Former Member

‎2006 Mar 08 1:56 PM

0 Likes
713

Hi,

Please check the process code (WE41/WE42).

Hope this helps..

Regards,

Shashank

Read only

Former Member

‎2006 Mar 08 2:00 PM

0 Likes
713

Hi Jim,

If Zero Communication idoc generated means, it is not able to find out partnersystem, otherwise it is successfull.

Regards,

Kiran

Read only

Former Member

‎2006 Mar 08 2:01 PM

0 Likes
713

Hi Abdul,

I believe the partner profile is setup properly only because it contains other inbound and outbound message types that are working. (background: partner type LS, number MQTEST, message type MATMAS, basic MATMAS01, receiver port A000000015 which points to the TCP/IP connection which is active).

The distribution model I am unsure about. I see one of the outbound message types defined, but no other type. But how are the other messge types working? I am not sure. I will try to research more.

Regards