on 01-13-2016 8:19 AM
Hi
I have created a plan distribution cycle with the sender rule to take as 3-Fixed Rate. After entering that, I have also entered the value in the the sender values & also the SKF value in KP46.
However when I ran the distribution cycle, it does not show any number of receivers, but the receivers are mentioend in the distribution cycle created
Appreciate if you'll could let me know if I select Fixed rate as the sender rule, whether there any other settings that needs to be done and also whether I have followed the correct process
Thanks
Arith
Hi,
If you select receiver rule as fixed one, need not maintain any planning data in KP46.
It is required where the option is Variable proportions & Plan SKF's.
As you have selected Fixed Proportions maintain Fixed amounts / percentages in the segment itself. (Under the tab Receiver Weighting factors.
Then run the cycle. you will get the results.
Regards,
Pavan Kumar Arvapally
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi
Thanks for the reply. Below are the settings I have done. As far as I know, if you select Fixed rate, the value you enter under sender values will get multiplied with the SKF you enter in KP46 and will you to distribute. This is the process I have followed. But I'm not getting any results
Thanks
Arith
Hi Pavan
Its working fine with the posted amounts. However the requirement is that the business wants to distribute a certain value which they going to decide & this particular value needs to be multiplied by the SFKs which they are going to enter and distribute to the receives during the distribution run
Due to this I think this can be catered via fixed rates for sender. Please let me know on this
Regards
Arith
User | Count |
---|---|
96 | |
7 | |
6 | |
6 | |
3 | |
3 | |
3 | |
2 | |
2 | |
2 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.