ECC6 IDES client copy error - RFC Destination FINBTR@ID#CLNT000

[Former Member]

hi,

i am trying to perform local client copy on my IDES system.

I have created a new cliet 100 with

logical sysytem as DEVCLNT100

Automatic recording of changes

changes to repository & cross-client customizing allowed

protection level 0: no restriction

eCATT & CATT not allowed

After this i logged into 100 with sap* & pass

selected profile : SAP_ALL

source client : 000

source client user masters :000

then Test Run

i get the following error

RFC destination : FINBTR@ID3CLNT000

proceed as folows

1. create an RFC destination with the target ZK>source client of client copy(in this acse 000)

2. check RFC destination works in sm59

3. Enter the RFC destination

- Transaction: FINB_TR_DEST

- client 000

4. start the client copy again

I did exactly the same

created ZK00 and checked the connections -- connection test OK

executed tcode FINB_TR_DEST, it showed client as 000 and Destination as FINBTR@ID3CLNT000

then again started Test Run but in vain got the same error

Please advice

Regards

palle

[former_member190272 · Accepted solution]

Hi,

Please check the SAP Note: 568784 - Termination with client copy (Financials Basis).Hope this help you.

Regards,

Pankaj

[Former Member · Accepted solution]

Hi,

1.In SM59, check with the proper IP address (or) hostname and the system no,

2.Does the User ID is having the Following Authorization Access to run the client copy.

And at last

3.Then check with connection test, then with Authorization test.

Regards

Nizam

[Former Member · Accepted solution]

Hi Pankaj,

Thanks for your advice, but i am bit confussed with the note. Can you please eloborate on what this note says.

first i have created RFC in sm59 in 100 with destination ZK00 ( as the pop up specified) . or do i need to give FINBTR@ID3CLNT000.

after that in client 000 i executed FINB_TR_DEST and that showed

cleint 000

Name : SAP AG

destination: FINBTR@ID3CLNT000

here i have a doubt , should i change the destination as ZK000 or the RFC created should be FINBTR@ID3CLNT000 instead of ZK00

Please revert back.

Regards

palle