on 07-07-2012 8:13 AM
Dear all ,
I am recording defects for inspection lot .
in the Catalog Causes I have may code groups .
But by default system is showing only one code group out of all these code grps from catalog type 5 .
is this by any settings or parameter ID ?
Pl guide
Hello Feed,
In Tcode-OQN6, select your Catalog Profile and click on tab-Catalog/CodeGroups (left side).
Check if any specific Code Group is assigned for Catalog-5 (Causes)... Make it '*' so that system will pick all relevant code groups.
Regards,
Anup
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
94 | |
11 | |
9 | |
5 | |
3 | |
3 | |
3 | |
3 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.