Initialisation issue using 0HR_PY_1_CE

[Sujai]

Hi,

I am using the datasource 0HR_PY_1_CE to extract payroll data. The problem is when i do a Full load I get all the data, but when i try to do a Init. it brings far less data than the full load.

I have tried extracting for a single employee and found that it is picking the records of only 1 period. But when i check the payroll results in PC_PAYRESULT it shows a lot other number of payroll runs.

What could be the issue here??

Regards,

Sujai

[former_member188080]

Hi,

Check for following thread and sap note in it

Thanks and regards

Kiran

[Sujai]

Hi all,

Thanks for your replies. Fixed the problem. its in the way the extractor works.

During delta or init load, the payroll extractor performs a check against this control record which means it does not accept any payroll results after current period, thus payroll data won't be extracted neither in init or delta mode, but it works for full load, we can verify that in RSA3 with corresponding personnel number.

This is the reason why the init brings less data than the full load.

Regards,

Sujai