Issue on initial load write to Identity Store pass

[laurent_vandenbemden]

Hallo All,

I encounter an issue on my IDM development system which I have been trying to solve for a couple of days.

It seems that the passes part of the initial load job are not able to write or read on my identity store anymore.

This is the error message I receive.

There is probably a parameter somewhere that I missed and need to change.

Can someone please advice on this issue?

Thx by advance,

Laurent

[Former Member · Accepted solution]

Hi Laurent ,

Can you please check whether below mentioned parameters are set for "Create Account Privilege or Create System Privilege Pass"

1 . Tab "Repository " - Is it linked to Repository MD1100 - If not please update the same

2 . Tab "Destination "

• Identity Store - Set the same to IDENTITY Store which is used in your Organization
• Entry Type - Set to MX_Privilege

If you have set all this ,& still getting an error , Can you please add a DESTINATION Pass also ..

Thanks ,

Jerry George

[laurent_vandenbemden · Accepted solution]

Hi Jerry,

I tried/verified the steps you mention and all seems right.

So it is still not working.

Any other ideas?

Thanks a lot,

Laurent

[Former Member · Accepted solution]

There is a known bug in IdM it can cause the job failed to run. This usually happened when you copy a job.

You need to go to the pass that has error. Go to Destination tab to pretend that you make some change. E.g to to DISPLAYNAME line put extra space that the end (after PRIV_SYSTEM_%$rep,$NAME% then remove the space. Then click on Save the pass.

Andy