on 06-26-2013 9:04 AM
Hello Gurus,
Appreciate if any one can help on the Cp-Cpk charts and process capability controls.
Example scenario for this is Like if Cpk of any workcenter is greater than 2.0 than it should not be used in the manufacturing of a particular FG material as the customer of this particular FG have asked for this restriction.
Regards,
Firoz Ansari
I know its old thread but MCXD report will do the job
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
After doing Result recording of SPC char ,you get "standard deviation" ( Sigma) for a MIC.
This can be use to calculate the Cp & Cpk of process.There is no direct calcution available for both these values.You have to customize a report which would give Cp ,Cpk for a MIC & for a FG product.
Make sure that you deifne a MIC as SPC in this case.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
You'd have to probably develop something custom for that. You can look at the early-warning functionality in the QMIS area. But I expect you'll need to do some customization. Especially to automatically block a workcenter. cp - cpK are not actually stored in the system that I have been able to find. Hence the need to build your own structures.
This would be a high complexity development.
FF
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
96 | |
10 | |
10 | |
5 | |
3 | |
3 | |
3 | |
3 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.