RABAX_STATE error in ELM

[former_member197655]

Hi Experts.

I am getting this short dump while  using ELM in  crm.8000/sap/bc/bsp/sap/crm_ui_frame/BSPWDApplication.do was terminated because of an error.RABAX_STATE type termination.

• The ABAP call stack was:
  Method: IF_SWF_RUN_WIM_UTL_INTERNAL~GET_SYSTEM_USER of program CL_SWF_RUN_WIM_LOCAL==========CP
  Method: GET_OWNER of program CL_SWF_UTL_MAIL===============CP
  Method: IF_SWF_UTL_MAIL~SEND of program CL_SWF_UTL_MAIL===============CP
  Method: IF_SWF_RUN_WIM_INTERNAL~SEND_ERROR_REPAIR_MAIL of program CL_SWF_RUN_WIM_LOCAL==========CP
  Method: DYN_SEND_ERROR_REPAIR_MAIL of program CL_SWF_RUN_WIM_STATE==========CP
  Method: EXECUTE_STATE_TRANSITION of program CL_SWF_RUN_WIM_STATE==========CP
  Method: IF_SWF_RUN_WIM_STATE~EXECUTE_STATE_TRANSITION of program CL_SWF_RUN_WIM_STATE_FLOW=====CP
  Method: SET_STATUS_INTERNAL of program CL_SWF_RUN_WIM_LOCAL==========CP
  Method: _SET_STATUS of program CL_SWF_RUN_WIM_LOCAL==========CP
  Method: IF_SWF_RUN_WIM_INTERNAL~SET_STATUS of program CL_SWF_RUN_WIM_LOCAL==========CP

Could you please guide me how to resolve this error.

Thanks in advance.

[juergenbaur]

Have a closer look into ST22.

br

Jürgen

[former_member197655]

Hi juergen

in st22 it shows "Unable to read RFC destination WORKFLOW_LOCAL_100"

[joaquin_fornas]

Hello

Basically RFC destination WORKFLOW_LOCAL_XXX (XXX is client number) is necessary for workflow and ALE communication and so on.

So could you please set up this destination by folloiwng procedure?

Logon to client 100->SWU3->Choose "Configure RFC Destination" and click on "Perform Automatic workflow customizing"

Make sure the flag in front of "Configure RFC Destination" turn to green, this destination should be generated automatically in SM59.

Then test again, see if the problem has been resolved.

Regards

Joaquin