on 2014 Nov 06 9:04 AM
Hi Colleagues,
Please can anyone off you help me in solving the below issue in C4C!
I have created a KUT field on a opportunity and I want to control the display using UI switch. I am not able to view the KUT fields in
the TI.
How do I bring the KUT field on the TI?
Regards,
Rupesh.
Hello Rupesh,
Could you clarify where on Opportunity have you created the extension field using KUT?
You will have to ADAPT the TI screen to show the extension field on it, follow the steps by going into the Opportunity TI screen in Adaptation Mode & make the extension field visible by putting a check against it.
BR
Ankur
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Ankur,
Thanks for the reply.
I'll explain in some detail. I have created a couple of KUT fields on the header and item of opportunity. These fields to be displayed on certain properties of the product that I enter in the opportunity. For example, if the product below to certain category, only then the field should be displayed at the header and item level, else it should be hidden.
In short I want to control the visibility of the fields through PDI and/or UI switch.
Thanks.
Rupesh.
Hi rupesh,
Using KUT (HTML5), you can control the Visibility of an extension field without any underlying logic involved, you can create certain types of fields & you can create extension fields with some very basic calculation rules.
What example you gave will need PDI/SDK development to control the visibility of the extension field based on certain condition, KUT will not be able to help you accomplish this logic.
You can also check the SDK where you can adjust field properties/visibility based on conditions such as dependent fields which do not need SDK coding, however you will have to use SDK/PDI for that.
BR
Ankur
Hi Ankur,
Thanks for the info.
As the fields have been added using KUT, I am unable to see those fields in the UI Designer in the respective Thing Inspector under Extensibility Explorer.
How can I view the fields added using KUT in the UI designer for the resp. component?
In the extensibility explorer, if I click on 'Add Extension Fields' against the active anchor I don't see the fields added using KUT even though those fields have been associated with resp. References in Studio.
Thanks in advance.
Regards
Rupesh
User | Count |
---|---|
33 | |
2 | |
1 | |
1 | |
1 | |
1 | |
1 | |
1 | |
1 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.