on 2008 Jan 10 5:54 AM
BW Experts:
We had the BW connect to R/3 which works well, but we lost the RFC connection occassionally.
When I wanna to restore or re-create the Source system in BW, I alway get error when go to "Active" step ( last step), the error message is "Error when opening an RFC connection"
I re-check all of pre-requisites:
SCC4 is open in BW and R3
SE03, system modification are open in BW and R/3
RFC user in R/3 and BW is full authorization
SM59 in both system are fine.
anyone know the reason about this problem? thanks
Regards
Jie
Hi jie,
RFC connection is manly defined by three parameters: Target host, Sys ID, Sys No. try to check again or ask your basis about any change on these 3 parameters in R/3 System.
Regards,
Chuong Hoang
Edited by: Chuong Hoang on Jan 10, 2008 7:19 AM
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
66 | |
10 | |
10 | |
10 | |
10 | |
8 | |
6 | |
5 | |
4 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.