on 2013 Jan 25 10:33 AM
Hi Experts
We are using Cross Plant config Material in Basic Data 2 and MRP3 views. In the configure variant tab, we need to do mass change of characteristics values.
I found CLMM t-code for class characteristics values mass change. But this doesn't allow the above config related characteristics value.
Can anyone help me how I can change the characteristics values inside the Configure variant tab in mass.
Also would like to know which table will have these values. It is not found in AUSP table.
Regards
Krishnaraj
give it a try , use transaction CUUPDMV or report RCUUPDMATVAR via SA38 to update the material variants after a model change.
example of it could be ,
A configurable material was changed. a new characteristic was included in a class and this characteristic is analyzed via object dependencies.
Alternatively, object dependencies are changed and calculated characteristic values change as a result. At the same time, many material variants, which would now have to be changed, exist in order to adjust the stored configurations to the new model. The system sees a material variant as a product variant of a configurable material whose characteristic values are already defined in the material master record. It is therefore treated as a stock material. In principle, the configurations of the material variants may be updated manually by executing transaction MM02 and calling the configuration in this case. An alternative is to execute CUUPDMV to update the material variants.
May be solve your issue.
Thanks
Ritesh
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Ritesh
I have a material master (for matl M1) in which the Basic Data 2 view has a Cross plant CM (Matl XXX) with matl type KMAT in the Client specific configuration section.
In the config Matl XXX, a class CL1 has been maintained - class type 300. this has 10 characteristics: CH1 to CH10.
For each material M1,M2, M3 etc we maintain values for CH1 to CH10.
Now I want to change the value of CH2 from 1.25 to 5.25.
I want to do it for all materials that have the characteristic CH2. I can list out all the material that have the class CL1 and char CH2.
How can I achieve this
Hope you understood my issue.
Can you pls explain in steps
Regards
Krishnaraj
It sounds like you just simple need to change material , as we do using MM02, so for it you can use LSMW or create a BDC for transaction MM02.
Check with you ABAPer, not a big task.
Mean while , i will check if there is any trasaction to change values in MV.
please mark threads helpfull if it helps you.
Thanks
Ritesh
User | Count |
---|---|
105 | |
8 | |
6 | |
6 | |
5 | |
5 | |
4 | |
3 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.