on 2016 May 02 3:36 PM
Hi Team,
When i run sproxy tcode and give the request i could able to see the Response message as expected .But when i run through SOAP UI /PI the request is been sent but response is blank.
I have used SUBMIT programs in the Code when i comment the SUBMIT Programs and pass some constants it is retaining response in PI but when my Submit Programs are been activated these are not retaining any response.
Kindly suggest.
Hello Lakshmi,
I know it is too late since the time you posted this. Still, answering it now since I went through the exact situation today.
Please check the Client Number of the SAP system which you have mentioned in the SOAP UI request and make sure it's going to the right one.
In my case, the HTTP Destination in SAP PO XI Receiver Channel towards S4 was pointing to the Wrong Development Client and I was getting an Empty Response. I used another Destination which was pointing to the Right Client and it worked!
Please note that this could just be one of the other possible reasons. Hence, updating it here for other people who would run into the same issue in future. Hope this helps!
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
5 | |
5 | |
4 | |
2 | |
1 | |
1 | |
1 | |
1 | |
1 | |
1 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.