05-06-2014 4:43 PM
Hi
I have set on a smartform a single row which contains two columns. The first column has an image, and the second has some text. I want the program to send the whole row to the next page if it does not fit the page, instead of breaking it up in separate portions. I already set the line break protection in Table > Details, but that did not work. Also, if i go to the output options in the text, the option to protect from break is not enabled. How can I do this?
Thanks,
Gabriel
05-16-2014 11:36 PM
Thank you very much all for your replies.
What I did at the end to solve the issue was to use a template with one row and two columns, and in each column I added the element I wanted.
05-06-2014 9:38 PM
05-06-2014 11:17 PM
Not sure how to make it work. As it basically is a table with one row, if I place it under a folder, the folder has the line protection checkbox disabled. And yes, it is a SE78 graphic.
05-07-2014 9:34 AM
05-07-2014 9:43 AM
you have the no page break checkbox in the table builder, as below:
05-07-2014 10:07 AM
05-07-2014 11:23 AM
OK, well I diasgree. I was highlighting a different approach to your solution that you gave in first answer and have since supported it. You were discussing the option on the folder itself, you stated:
"create a folder above, after it drag and drop your line into the folder and there you got the option to protect the line. I think this will work, but never tried it with an image.
What about the settings of the image. It is a SE78 graphic, is it?"
I am suggesting to mark the line, in the table builder, as another solution. I am sure one of these solutions will be explored - based on which is easier to implement based on the form design so far!
Cheers
05-07-2014 12:09 PM
No need to argue, but you just had to click on the first screenshot in the this post:
Florian Henninger May 7, 2014 10:34 AM
PS: It is marked yellow
05-07-2014 1:19 PM
05-07-2014 3:41 PM
05-08-2014 12:07 AM
Thank you very much for your replies. Actually, I had already checked that option, but it makes no difference.
05-08-2014 3:13 PM
05-08-2014 4:42 PM
there could be several other factors....
do you have any of the following
And additional events set that may interfere?
have you checked this setting?
If you could supply the xml of your form, i will upload it and have a look at it.
Cheers
05-16-2014 11:36 PM
Thank you very much all for your replies.
What I did at the end to solve the issue was to use a template with one row and two columns, and in each column I added the element I wanted.