2011 May 14 3:40 PM
Hi, please advise.
I have two business processes, one old process and another new - optimized process. Question is how to measure the system load (total) for realization of the first - old process and new process to measure difference of how the processes load the system.
I need to measure the system load only for realization of the processes (each process consists of several transactions).
I want to measure the load for realisation of the first process and know how it loads the system and then make the same measurement for the second process - so two separate measures are needed.
I work in SAP R/3 Enterprise.
Thank you for any advice.
Lubos
2011 May 15 10:20 AM
Hi Lubos,
use system-tool run time analysis for each transaction, look at the detailed analysis and decide which values you use for time and memory consumption.
Regards,
Clemens
2011 May 15 10:20 AM
Hi Lubos,
use system-tool run time analysis for each transaction, look at the detailed analysis and decide which values you use for time and memory consumption.
Regards,
Clemens
2011 May 16 12:02 PM
Hi,
i have tried tx SAT - but it is not available for me, so i make measurements thorugh se30. There is no problem with transactions like FB60, FF67 etc. but when I try to measure the F110 transaction system shows an error during the measurement. Message number: S7068, diagnosis: see note 170470.
Do you know what problem could it be.
I´m a newbee in this.
Thank you for any replies.