11-15-2006 3:14 PM
hello friends,
I've developed a zscript and zprg which are to be printed when i run the transaction VF02. i'm able to see my zscript when i run the transaction.
But the problem is im unable to see the data which is being fetched by the zdriver prg..although the data is coming into the workarea...
The data is getting printed when i run the zprg, when i execute it from the transaction it is not getting printed...
what could be the reason?
Early reply would be appreciated.
Regards,
Krishna
11-15-2006 3:26 PM
Hi sai,
when u r running from the transaction the data is present in the transaction so output it triggered based on the output type
like the process is
this gets triggered
as perform --driver program
and form -- script
in the routine entry1
and outputs the data to script and here it will not reach to the end of selection of the Zdriver program which means the list is not triggered ..so u will not see the o/p
when run from a transaction .
whereas when u run the z driver program
it will reach the end of selection and list is triggered .
regards,
VIjay
Message was edited by:
vijay k
11-15-2006 4:55 PM
Hi Vijay,
Thank You for your reply.
Could you please elaborate on the explanation given by you.
How do we technically approach it, If possible, please provide some steps.
Regards,
krishna
11-15-2006 3:48 PM
is the output type set to the driver program in NACE for V3 - billing. The output type also should be set to the transaction in the access sequence by the functional person or for testing u can check the output type in VF02
11-15-2006 4:58 PM
Hi,
The output type is set. Im able to see the form when i execute the transaction, but im unable to see data in the windows, when the form is printed from the transaction.
Regards,
Krishna
11-15-2006 6:43 PM
did u put a break point in the driver program to check and see if the data is being populated when called from vf02 also activte the SAPSCRIPT DEBUGGER to check is the data is sent to the script.