on 07-22-2005 6:51 PM
Hello..
If i wanted to send a message from SAP to webserver..what configuration is required in I'Builder?
Thanks..
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi,
Look at the following how to guide
https://www.sdn.sap.com/irj/servlet/prt/portal/prtroot/com.sap.km.cm.docs/library/xi/xi-how-to-guide... to set up a web service related scenario in xi.pdf
Naveen
I need to send a message from sapto xi then to webserver...it is not possible to use adapters?it is mandatory to use proxy?can u give me bit clarification...
Thanks
Hi Feroz,
There are two ways for you to send messages from sap to xi.
1. if your sap system has xi2.0 or xi3.0 add on, you could then use outbound proxy to call the interface in XI
2. Or you can use RFC adapter for sending data from r3 to xi (you should have defined a registered program between r3,xi)
Proxies are recomended but only if you have the xiaddon installed on ur system. (TCode: sicf)
Bye,
Navee
could you please tell me what SWCV has to be imported from SLD?
hi,
look the following link
http://help.sap.com/saphelp_nw04/helpdata/en/14/555f3c482a7331e10000000a114084/frameset.htm
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.